Standard Stacks

Direct Mount Stacks
These (shoulder mount) stacks install with a set screw and will fit our 60°, 90°, 60/90°, 90/90°, and Dual Runner Basic Build Kits. As with the Standard Stacks, the Direct Mount Stacks are available tapered or trumpeted and 2.5” or 3.5” in length.

SuperSucker Stacks
Superior design and quality make Wimmer SuperSuckers a popular choice of top builders. With each stack we offer your choice of a 60 or 80 mesh internal screen for filtration. These (shoulder mount) stacks use two socket set screws to install and are compatible with our 60°, 90°, 60/90°, 90/90°, and Dual Runner Basic Build Kits. NOTE: Also available with cotton pleated filter for stock 88” and smaller motors.

UltraSucker Stacks, a Wimmer Exclusive
Our UltraSucker velocity stack is a cross between a top quality velocity stack and an air filter. A pleated filter, similar to our HPF line of filters found on pages 14-15, is housed within a massive velocity stack!

These (shoulder mount) stacks use two socket head screws to install, and will fit our 60°, 90°, 60/90°, and 90/90° Basic Build Kits.

Spike Stacks
Improved looks, superior quality, and increased air flow are all reasons to choose this stack to complete your intake. Machined completely from 6061 billet aluminum and then chromed to a show finish this stack demands attention. The internal filters are available in 4 different colors for even more options. These stacks use 2 socket head screws to install, and will fit our 60°, 90°, 60/90°, and 90/90° Basic Build Kits . 

If you are looking for a Dual Runner look with the superior Wimmer Spike, we have just released the new SPIKE design for our patented Dual Runner Setup - call for details.

Direct Mount Stacks

2.5” Tapered
DMSS

2.5” Trumpeted
DMST

Basic Build Components
If you are choosing your components to complete your VSA Basic Build, choose from the “Flange Mount” stacks found on this page. If you are completing a Basic Build Kit that incorporates an elbow choose from the “Shoulder Mount” stacks found below.

These stacks only fit Wimmer brackets and will not bolt directly to carburetors. If you are upgrading your older Wimmer velocity stack(s) be sure to let us know when you are placing your order.
Standard Velocity Stacks
Wimmer classic air intakes offer superior air flow as proven on our CFM Flow Chart illustrated here. Choose the straight taper design or the trumpeted design for more flare. Then choose your size, we offer 2.5” and 3.5” long stacks.

SuperSucker Shorty Stacks
These velocity stacks offer superior design and quality. A massive air intake with all the filtration benefits you will need. You have your choice of a 60 or 80 mesh internal screen for filtration. These (flange mount) stacks have a 3-hole bolting pattern and will fit our VSA Basic Build. NOTE: This stack is available with a cotton pleated filter for stock 88” and smaller motors.